|
Post by arkay99 on Feb 23, 2018 20:46:49 GMT -8
I just downloaded and installed Raven 3.5.0. It works with my Pro Tools HD 12.4.0 setup (ran UPDD configure). But doesn't communicate with Studio One. The only button that responds is Hide Raven and the Raven icon to reshow Raven. I have run the UPDD configure utility and it sees both my monitors in status and I can draw multi-touch with test. I can do swipes and gestures with the Studio One interface, but Raven buttons and controls don't respond.
I have the Touch Input tab set as: Enable TUIO multi-touch devices on UDP port 3333 Connect multi-touch device with monitor number 0 This Number of attached multi-touch devices 2
I have a Raven license for Pro Tools and a Batch Commander for Studio One license for Studio One. When I launch S1 (or Pro Tools now) I get a dialog at start that asks if I want to select DAW at Start...it's checked, then I select Studio One in the drop down and Raven loads with MTi Studio One displayed in the info box...
Do I need a separate license for Studio One in addition to my Batch Commander license? Or have I missed something in the S1 setup that was previously done for Pro Tools?
|
|
|
Post by arkay99 on Feb 24, 2018 20:37:06 GMT -8
This has been solved. I didn't set up the TUIO port, Gestures for Studio One, and V-Control devices in S1. RTFM, or in this case WTFV.
|
|