Post by gnapier on Feb 17, 2019 17:30:24 GMT -8
Hey Jamey,
So my C10 alignment was suddenly whack today. No worries. I went through all of the videos and the article you posted a couple of years ago. Even imported the old 9.5 preferences into C10. Everything ALMOST lines up...except for the vertical alignment of the faders on the internal mixer. They are consistently off and also cutoff prematurely on the vertical. (They disappear if you drag them below the lower line of the small white box.) Check out the picture.*
I'm figuring there is something dead simple I'm not doing. Any suggestion?
Thanks.
George
* - (Says forum has exceeded space limit, so you can grab the pic here: we.tl/t-3Lq8icNKdk)
So my C10 alignment was suddenly whack today. No worries. I went through all of the videos and the article you posted a couple of years ago. Even imported the old 9.5 preferences into C10. Everything ALMOST lines up...except for the vertical alignment of the faders on the internal mixer. They are consistently off and also cutoff prematurely on the vertical. (They disappear if you drag them below the lower line of the small white box.) Check out the picture.*
I'm figuring there is something dead simple I'm not doing. Any suggestion?
Thanks.
George
* - (Says forum has exceeded space limit, so you can grab the pic here: we.tl/t-3Lq8icNKdk)
