|
|
Post by James Hurley on Nov 9, 2015 16:30:41 GMT -8
I have a script I wrote, mostly with key commands, one quick list script, that basically cursers back by the nudge amount, breaks the clip, cursors forwards but the nudge amount, creates a fade in, increases the nudge amount 5 times, cursors forward by the nudge amount, breaks the clip, reduces the nudge amount and cursors back, creates a fade out, tabs back to the beginning of the the fade in it made, selects the clip prior to the fade in, mutes it, and tabs forward to the end of the fade out it made. Somewhere in there it resets the nudge value back to the minimum. I also have it set to turn off tab to transient (the quick list command I referred to at the start of this post) before it does anything else and turn it back on again at the end of the script. The issue I am having is that this command works perfectly only sometimes, then it will start making breaks and fades with the wrong nudge amounts like its missing key commands.
|
|
|
|
Post by jameyz on Nov 9, 2015 18:09:15 GMT -8
Please upload the Bc and I can see if something went wrong in the script maybe when duplicating or something. Otherwise , can u reset The nudge value every time ? Then when you enter the command for nudge, no matter what it always will start from zero.
|
|
|
|
Post by James Hurley on Nov 9, 2015 18:13:08 GMT -8
Please upload the Bc and I can see if something went wrong in the script maybe when duplicating or something. Otherwise , can u reset The nudge value every time ? Then when you enter the command for nudge, no matter what it always will start from zero. Not entirely sure how to do that, you just want the session? I switched out the "CLICK TAB TO TRANSIENT" for the "TAB TO TRANSIENT" quick list command and its still causing issues... I have increased delay times... still not consistently doing what I want. |
|
|
|
Post by James Hurley on Nov 9, 2015 18:23:31 GMT -8
|
|
|
|
Post by James Hurley on Nov 9, 2015 18:35:37 GMT -8
Yea... I think the issue is with the tab to transient commands... both of them in the quicklist. They don't always work
|
|
|
|
Post by James Hurley on Nov 9, 2015 19:25:44 GMT -8
They don't work almost EVER. lol... It seems to click is a random number of times... and most of the time it doesn't result in the opposite state of the button. Also, I have tried setting the delay time to no avail... also I tried no delay.
|
|
|
|
Post by jameyz on Nov 9, 2015 20:16:56 GMT -8
Can u save the BC then export it from the quicklist and upload it?
|
|
|
|
Post by jameyz on Nov 9, 2015 20:41:56 GMT -8
Also, are u putting the delay time before the "click" so something like 3000ms before "tab to transient" and after. Also, are there any other windows open blocking the tab to trans click?
|
|
|
|
Post by James Hurley on Nov 10, 2015 13:49:09 GMT -8
|
|
|
|
Post by jameyz on Nov 10, 2015 16:57:36 GMT -8
Try this one, I switched out the Tab to Trans Click with the key command (wasn't easy since BCer doesn't accept that command) but give this a try.. CLEAN -NEW TAB TO TRANS-.ravbc (1.89 KB) it seemed to work ok, but i am not sure which nudge value you are starting at.. Although if you add "option command numpad +" X5 it will always go to the highest point then you can "option command numpad -" down to the desired value.. |
|
