|
Post by eatthebeat on Jun 20, 2018 16:53:13 GMT -8
I went to create a BC for setting the left locator (cycle) position by the playhead and noticed a V-Control assignment in the Raven Key Commands. Then I looked in quicklist to find where this is used and didn't see the BC I need. I've attached a couple screenshots showing what I see... I know I can assign a key command, but I'm wondering if we have access to these V-Controls in our BCs? Also, side-note, does the 3rd screenshot show correct V-Control prefs? For instance, does "always use 24 tracks if raven installed" override the DAW track count? Thanks a million!!!
|
|
|
Post by jameyz on Jun 21, 2018 8:40:25 GMT -8
There is no way to launch a V-Control Pro setting from a Batch Commands, so you will have create a custom key command for that feature, then be sure to resave your custom RAVEN key commands so it doesn't get overwritten at re-install.
When V-Control Pro is set to 24, this just means it can access 24 faders at a time until the user banks to the next 24.
|
|
|
Post by eatthebeat on Jun 21, 2018 14:16:20 GMT -8
Thx Jamey, really appreciate ur attention to these posts
|
|