|
|
Post by Keybeeetsss on Sept 25, 2017 8:25:59 GMT -8
I just purchased the CORE 2 STATION. I'm in a commercial studio, so the Trashcan isn't near the screens @all.
Do the screens have to be on 2 separate USB ports, or can they be on the same 1? Mind you, either way this will be with an extender or some sort? USB PORTS are VERY limited on the Trashcan Macs as I'm sure you know...
Thanks in advance...
|
|
|
|
Post by jameyz on Sept 25, 2017 8:57:59 GMT -8
I just purchased the CORE 2 STATION. I'm in a commercial studio, so the Trashcan isn't near the screens @all. Do the screens have to be on 2 separate USB ports, or can they be on the same 1? Mind you, either way this will be with an extender or some sort? USB PORTS are VERY limited on the Trashcan Macs as I'm sure you know... Thanks in advance... For best results they should be in separate ports. If the screens are very far away you will probably need some CAT5 extenders. Some powered USB hubs work ok, I am able to use my 2 Ravens in one powered Belkin USB, but the USB run is still pretty close the computer. You may need to get thunderbolt HUB which will buy you another HDMI port and more 2 USB ports. slatemt.zendesk.com/hc/en-us/articles/218510678-Using-a-Thunderbolt-HUB-to-support-connecting-a-Thunderbolt-DAW-Interface-with-Dual-Ravens |
|
|
|
Post by Keybeeetsss on Sept 25, 2017 9:44:49 GMT -8
Thank you. Hopefully that'll fix the Flashes of white noise I'm getting from screen 2 as well?..
|
|
|
|
Post by jameyz on Sept 25, 2017 12:13:25 GMT -8
Thank you. Hopefully that'll fix the Flashes of white noise I'm getting from screen 2 as well?.. HI, The flashes and noise aren't USB issues. That is a graphics card issue, you must be overdriving your graphics card or your cable length is too long.. You can turn down the volume on the back of Raven, as well as set your Audio I.O to not come out of HDMI. Also, you can try a different outlet or a ground lift. Try a one way HDMI cable uedata.amazon.com/FORSPARK-Built-Booster-Unidirectional-HDMI2-0-Receiver-Computer-Compatible/dp/B00D8WVLX2/ref=sr_1_2?s=electronics&ie=UTF8&qid=1495237591&sr=1-2&keywords=75+ft+HDMI+Cable+one+wayElse, reset the pram. 1. Shut down your Mac. 2. Locate the following keys on the keyboard: Option, Command (⌘), P, and R. You will need to hold these keys down simultaneously in step 4. 3. Turn on your Mac. 4. Immediately press and hold the Option-Command-P-R keys. You must press this key combination before the gray screen appears. ... 5. Release the keys. |
|
|
|
Post by Keybeeetsss on Sept 25, 2017 13:04:45 GMT -8
Ok thanks again. I ordered the 1 way cable, so I'm report back once I get that...
|
|
