I am wondering if anyone else has experienced a periodic but consistent buzz when using the mti. I am using Pro Tools 11.3 and an iMac with I7 and 32GB ram and a 500GB SSD with an external 500GB SSD connected as the drive for the Pro Tools data. I am using a behringer fca1616 ( I know not the greatest, but is for testing) VIA firewire. It is only when I have the raven software running so I wasnt sure if it is software or hardware related. The buzz is about 5 seconds long and will occur every 2-3 minutes. I have my outputs from the 1616 going to an external mixer then to my studio monitors. Once again... the buzz only happens while I am using the Raven software. If I turn it off but the mti is still on as a monitor, there is no buzz.
No the buzz does not occur when only pro tools is open.. .it is only when using the raven software... I am using an iMac 27" with 32gb ram... I have a new studio with configured power where each side of the room is on its own breaker and the lights are on their own as well. This means the computer is on a separate breaker and power conditioner than the MTI. Power is grounded correctly. I have the slate plugged into a monster power center pro 950 rack mounted clean power conditioner. THe buzz isnt constant... it happens about every 2-3 minutes and lasts only about 4-5 seconds.
Last Edit: Aug 6, 2015 11:02:36 GMT -8 by pappatoad