|
Post by randb1 on Feb 26, 2018 8:17:32 GMT -8
When I open Batch Commander to change or add a new BC, my mouse cursor disappears from the screen. I move the mouse around and click until it finally re-appears, and then I can use it to edit or add the batch commands. I know I can use touch to do this, but I have large fingers and sometimes it's hard for me to select the right line, edit, etc. because the print or line is smaller. Plus, I just prefer to use the mouse for these changes or adds. Anyone else have this problem, or can tell me why my mouse cursor disappears? This only happens when I open BC, the rest of the time, the cursor stays visible.
|
|
|
Post by jameyz on Feb 26, 2018 10:25:27 GMT -8
When I open Batch Commander to change or add a new BC, my mouse cursor disappears from the screen. I move the mouse around and click until it finally re-appears, and then I can use it to edit or add the batch commands. I know I can use touch to do this, but I have large fingers and sometimes it's hard for me to select the right line, edit, etc. because the print or line is smaller. Plus, I just prefer to use the mouse for these changes or adds. Anyone else have this problem, or can tell me why my mouse cursor disappears? This only happens when I open BC, the rest of the time, the cursor stays visible. is this RAVEN or Batch Commander?
|
|
|
Post by randb1 on Feb 26, 2018 10:55:31 GMT -8
I guess it's Raven, I've never purchased Batch Commander separately, I've just always used it through Raven.
|
|
|
Post by jameyz on Feb 27, 2018 10:08:34 GMT -8
I guess it's Raven, I've never purchased Batch Commander separately, I've just always used it through Raven. Batch Commander is a slimmed down version of Raven, so the Raven MTi2 has all the Batch Commander capabilities built in. The RAVEN does hide the mouse so that it looks smoother when grabbing faders. You could either tab the display about the RAVEN to get the mouse to show up. Or you could record a mouse click that moves your mouse to any X/Y you want.
|
|
|
Post by randb1 on Feb 27, 2018 14:16:11 GMT -8
Ok, got it Jamey thanks, I just wanted to make sure something wasn't wrong but it sounds like it's working as designed. thanks again!
|
|