|
Post by JerEvil on Oct 27, 2017 22:35:40 GMT -8
Anyone getting white noise/static with Raven software running? After about 30 minutes of tracking I start getting static-like sounds on my tracks. If I turn the Raven software off it goes away.
|
|
|
Post by jameyz on Nov 3, 2017 9:31:09 GMT -8
Anyone getting white noise/static with Raven software running? After about 30 minutes of tracking I start getting static-like sounds on my tracks. If I turn the Raven software off it goes away. Sounds like a ground loop with the USB or HDMI. How is the RAVEn plugged into the computer?? 1. Turn the volume down on the back of the Raven 2. Plug the RAVEN power supply into a different outlet. 3. Replace the USB cable or try a different port. 4. Replace the HDMI cable or try a different port or converter.. Here is the link to start a support ticket for the Raven.. slatemt.zendesk.com/hc/en-us/requests/new?ticket_form_id=61177
|
|
|
Post by JerEvil on Nov 3, 2017 9:46:25 GMT -8
The Raven is plugged in via HDMI.
1. Turn the volume down on the back of the Raven - Will do 2. Plug the RAVEN power supply into a different outlet. - It is plugged into a Furman Power Conditioner. Should I plug it into the wall instead? 3. Replace the USB cable or try a different port. - Will do 4. Replace the HDMI cable or try a different port or converter.. - No other port on my Mac. Not using a converter. Can try a new HDMI though.
|
|
|
Post by jameyz on Nov 3, 2017 9:47:30 GMT -8
ok, if there is no convert then you should be fine..
I would try the other power outlet, if possible the same one the computer is in maybe..
|
|
armin
New Member
Posts: 10
|
Post by armin on Apr 11, 2018 10:06:00 GMT -8
i had to mute the audio of the mti2, too
|
|