|
Post by Neil Sutherland on Sept 28, 2017 20:42:34 GMT -8
Is there any way to change track outputs on a batch command in Logic, can do all sorts of other things but can't get this to work. It is not a mouse click, it is a hold and select??
Must be a simple way to do this...
Thanks any help much appreciated
|
|
|
Post by jameyz on Sept 29, 2017 8:37:43 GMT -8
Is there any way to change track outputs on a batch command in Logic, can do all sorts of other things but can't get this to work. It is not a mouse click, it is a hold and select?? Must be a simple way to do this... Thanks any help much appreciated right click should work. So I would use the Inspector to hit the output or maybe you can use the Mixer in single mode.
|
|