|
Post by martinb on May 6, 2017 6:54:19 GMT -8
Hi all, I have started work today and a lot of my batch commands have stopped working? Even when using the default batch commands they don't work, the screen flashes and then nothing happens. When trying to add commands from the Quicklist these don't work either? I recently updated to the 3.3 for Logic X and all was working fine until today.
Thanks in advance
|
|
|
Post by jameyz on May 11, 2017 9:06:53 GMT -8
Hi all, I have started work today and a lot of my batch commands have stopped working? Even when using the default batch commands they don't work, the screen flashes and then nothing happens. When trying to add commands from the Quicklist these don't work either? I recently updated to the 3.3 for Logic X and all was working fine until today. Thanks in advance Do you have the Raven Key commands setup in Logic? Here is the link to start a support ticket for the Raven.. slatemt.zendesk.com/hc/en-us/requests/new?ticket_form_id=61177
|
|